|
Socoder -> Misc Languages -> Getting started with Raspberry PI Pico - Jiggly Noise |
|
| Sun, 30 Oct 2022, 14:40 | |
cyangames
|
Found a 36mm 3w 4ohm speaker on ebay for £5 so that may end up being the thing, we shall see 
-=-=- Web / Game Dev, occasionally finishes off coding games also! |
| Mon, 31 Oct 2022, 11:40 | |
|
cyangames
|
Gahh, these are slightly smaller!! www.ebay.co.uk/itm/255392154315 (notes to self) -=-=- Web / Game Dev, occasionally finishes off coding games also! |
| Mon, 31 Oct 2022, 15:28 | |
|
cyangames
|
Whoops! got two wires soldered to the wrong contacts on the PI! had my scl and sda the wrong way around! Time to undo the damage then.
-=-=- Web / Game Dev, occasionally finishes off coding games also! |
| Mon, 31 Oct 2022, 16:23 | |
|
cyangames
|
"Desoldered" them with the iron and a simcard tray opener, hella jank but it works!
-=-=- Web / Game Dev, occasionally finishes off coding games also! |
| Mon, 31 Oct 2022, 17:01 | |
Jayenkai
|
Somebody get this guy some Meccano!!
|
| Mon, 31 Oct 2022, 17:06 | |
|
cyangames
|
Ha! Yeah, and some powerful, silent servos  I should re-watch weird science sometime
-=-=- Web / Game Dev, occasionally finishes off coding games also! |
| Fri, 04 Nov 2022, 02:04 | |
|
cyangames
|
I ended up ordering a speaker from eBay, mainly due to convenience and yup, 3w, 8 ohms is loud enough for the task! The speaker is a little large at 38mm X 38mm but could be incorporated into some sort of collar perhaps? I need to order the lipo shim next or some sorta battery pack, li-ion is going to be way more power to space efficient though, will do some reading up tonight I imagine. -=-=- Web / Game Dev, occasionally finishes off coding games also! |
| Fri, 04 Nov 2022, 02:36 | |
Jayenkai
|
Careful, now!! Using a cell is one thing. Recharging it without it exploding is quite another! Good luck... -=-=- ''Load, Next List!''
|
| Fri, 04 Nov 2022, 03:42 | |
|
cyangames
|
Aye, perhaps I should just walk ( connect it to a small mobile power bank ) before I run, especially whilst testing and refining the project. Although, this could do the trick https://shop.pimoroni.com/products/pico-lipo-shim?variant=32369543086163 As could this for better space saving , one less board to wire up, along with a nicer and, more importantly, safer connector https://shop.pimoroni.com/products/pimoroni-pico-lipo?variant=39386149093459 Also, Check out this teeny tiny PKCell! https://shop.pimoroni.com/products/lipo-battery-pack?variant=20429081991 I'll probably go for the latter after I'm satisfied with how this intial prototype works and sounds! The standard pico has 2Mb of flash so upping that to 4Mb or 16Mb without relying on a micro SD card interface makes things much easier. There may be some other, smaller speakers I can use also. I guess, that 3d printing a strong and sturdy container around the PKCell would be pretty high priority in order to keep it as safe as possible inside a collar,as it's going to be prone to bending otherwise which is really want to avoid! Ideally situated around the back, with some rounding to keep it all close, along with the speaker round the front, yay product design! -=-=- Web / Game Dev, occasionally finishes off coding games also! |
| Thu, 10 Nov 2022, 02:43 | |
|
cyangames
|
Tried attaching a battery pack yesterday, apparently it didn't supply enough juice to do anything, 2xAAs are not enough it seems, i was hoping that would result in 3v which is within the Pico's tolerances but ehhh, never mind. It does happily run through a USB powerstick / Phone charger though which isn't really surprising. Circuitpython continues to be a picky little thing about everything currently including the wording for a standard type : bytearray Python is weird and I don't like it much at all. -=-=- Web / Game Dev, occasionally finishes off coding games also! |
| Thu, 10 Nov 2022, 02:47 | |
|
Jayenkai
|
9v Square battery? Probably too high..
|
| Thu, 10 Nov 2022, 02:51 | |
|
cyangames
|
Yeah, I think I need 3 AA batteriess to being it up to 4.5Vwhich should do the job, just gotta buy another container for them I think, then see how that goes.
-=-=- Web / Game Dev, occasionally finishes off coding games also! |
| Tue, 29 Nov 2022, 13:56 | |
spinal
|
I've been thingking recently..... adding a screen to a pico + speaker + battery etc. == pico handheld OK, hear me out.... Use something like Jays JSE language to code the games, that way the *could* be run from a microSD card (assuming the pico has enough ram to do such a thing) and boom! Popular gadget than anyone can build and code for! -=-=- Check out my excellent homepage!
|
| Tue, 29 Nov 2022, 14:33 | |
|
cyangames
|
Yeah, that would work, just add a couple of buttons and it's all good ðŸ‘
-=-=- Web / Game Dev, occasionally finishes off coding games also! |
| Tue, 29 Nov 2022, 14:40 | |
|
Jayenkai
|
JSE would need one heck of a lot of rewriting to get it out of being stuck in a Javascript/Canvas wrapped engine. It uses tons of Javascript variable-array-key stuff, for starters. Then you've the actual usability, too. No keyboard = severe limit. You'd have to pico+speaker+decent browser+probably a keyboard + battery, and by that point.. Most cheap phones could probably do a better job of it, if I'm honest. I mean, I know there's the whole "Making for the sake of making" thing, but .. I dunno, that one seems a bit unrewarding! If you wrote a better, faster, more specific BASIC like language and got it to run really fast on a small system, then that'd be much better. Perhaps that could be a challenge for the new year? Make your own little Minigame Engine for SBCs! -=-=- ''Load, Next List!''
|
|
|
| |||
|
| ||||